Netgear WC7520 - ProSafe 20-AP Wireless Controller Reference Manual
Configuring Network Settings
68
ProSafe 20-AP Wireless Controller WC7520
Figure 30.
The DHCP Server List shows the DHCP servers that are already configured on the
wireless controller.
wireless controller.
2.
Click Add. The Add DHCP Server pop-up window displays:
Figure 31.
3.
Configure the settings as explained in the following table:
Table 11. DHCP settings
Setting
Description
Enabled
Select this check box to enable the DHCP server. When the check box is cleared,
the DHCP server is disabled.
the DHCP server is disabled.
Use VLAN Interface
Select this check box to allow the DHCP server to function with multiple VLANs.
VLAN
Enter the DHCP server VLAN ID. The range is between 1 and 4094. The DHCP
server will service this VLAN.
server will service this VLAN.
IP Network
Enter the IP address for the wireless controller in the VLAN that you have
specified in the VLAN field. If you have not selected the Use VLAN Interface
check box, the IP address of the wireless controller’s management VLAN is
used.
specified in the VLAN field. If you have not selected the Use VLAN Interface
check box, the IP address of the wireless controller’s management VLAN is
used.