Netgear WC7600v1 - ProSAFE Wireless Controller User Manual

From left to right, the front panel of models WC7600 and WC9500 show the components that 
are described in the following table.

The wireless controller comes with a single internal power supply but supports an optional 
second power supply for power redundancy. The power supplies are hot-swappable.

The following figure shows the back panel of the wireless controller with a single internal 
power supply, the power supply connector, and two double fans.

Digital counter

Displays the number of connected access points that are in a healthy state.

System LEDs

From top to bottom: Power LED, Status LED, Fan LED, and Stack Master LED. 
These LEDs are described in 

Reset button

Using a sharp object, press and hold this button for about 10 seconds until the Status 
LED blinks and the wireless controller returns to factory default settings. 

If you reset the wireless controller, all configuration settings are lost and the default 
password is restored.

USB port

One USB 2.0 port for external storage of floor heat maps, saving of the syslogs, and 
backing up the configuration. The USB port supports FAT32 file systems.

SFP+ slots and LEDs

Two SFP+ slots for optional 10GE SFP+ or 1G SFP gigabit interface converters 
(GBICs), each slot with an LED.

Ethernet port and LEDs

One 10/100/1000 Mbps LAN Ethernet port with an RJ-45 connector, left LED, and 
right LED. The Ethernet port provides switched N-way, automatic speed negotiating, 
auto MDI/MDIX technology.

Console port

RS232 port for connecting to an optional console terminal. The port provides a DB9 
male connector. The default baud rate is 9600 bits/second. 

The console port is for debugging under guidance of NETGEAR technical 

support only.

Power supply connector

Slot for an optional
second power supply

Removable power supply

Removable fans