Netgear WC7600v1 - ProSAFE Wireless Controller User Manual
Installation and Configuration Overview
98
ProSAFE Wireless Controller
13.
(Optional but recommended) Back up the configuration.
Choose a Location for the Wireless Controller
The wireless controller is suitable for use in an office environment where it can be
freestanding on its runner feet or mounted into a standard 19-inch equipment rack.
freestanding on its runner feet or mounted into a standard 19-inch equipment rack.
Alternatively, you can rack-mount the wireless controller in a wiring closet or equipment room.
A mounting kit, containing two mounting brackets and screws, is provided in the wireless
A mounting kit, containing two mounting brackets and screws, is provided in the wireless
controller package.
Consider the following when deciding where to position the wireless controller:
•
The unit is accessible and cables can be connected easily.
•
Cabling is away from sources of electrical noise. These include lift shafts, microwave
ovens, and air-conditioning units.
ovens, and air-conditioning units.
•
Water or moisture cannot enter the case of the unit.
•
Airflow around the unit and through the vents in the side of the case is not restricted.
Provide a minimum of 25 mm or 1 inch of clearance.
•
The air is as free of dust as possible.
•
Temperature operating limits are not likely to be exceeded. Install the unit in a clean,
air-conditioned environment. For information about the recommended operating
temperatures for the wireless controller, see
air-conditioned environment. For information about the recommended operating
temperatures for the wireless controller, see
.
Deploy the Wireless Controller
wireless controller in your network.
To deploy the wireless controller:
1.
Disconnect the wireless controller from the computer that you used for configuration.
2.
(Optional) Reconfigure the computer back to its original TCP/IP settings.
3.
Place the wireless controller where you intend to deploy it.
4.
Connect an Ethernet cable from the wireless controller to a switch or router on your wired
network.
network.
5.
Connect the power cord to the wireless controller and plug the power cord into a power
outlet.
outlet.
The Power, Status, and Ethernet LEDs light. If any of these do not light, see