Netgear WNDAP350 – ProSAFE Dual Band Wireless-N Access Point User Manual

Enter the IP Address fields of the WNDAP350. 

DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is 
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless 
access point will get its IP address, subnet mask and default gateway settings 
automatically from the DHCP server on your network when you connect the 
WNDAP350 to your LAN.

IP Address. Enter the IP Address of your wireless access point. The default IP 
address is 192.168.1.1. To change it, enter an unused IP address from the address 
range used on your LAN; or enable DHCP.

IP Subnet Mask. The Access Point will automatically calculate the subnet mask 
based on the IP address that you assign. Otherwise, you can use 255.255.255.0 (the 
default) as the subnet mask. 

Default Gateway. Enter the IP address of the gateway for your LAN. For more 
complex networks, enter the address of the router for the network segment to which 
the wireless access point is connected.

Primary DNS Servers. The WNDAP350 will use this IP address as the primary 
Domain Name Server used by stations on your LAN. 

Secondary DNS Servers. The WNDAP350 will use this IP address as the secondary 
Domain Name Server used by stations on your LAN. 

Network Integrity Check. Check this box to enable the WNDAP350 to validate that 
the upstream link is active before allowing wirelessassociations.If you set this option 
you must ensure your default gateway is configured.

Click Apply to save your basic IP settings.

The following sections describe how to configure the wireless settings available in both the 
802.11b/bg/ng and 802.11a/na modes.



From main menu under Configuration, select Wireless. The Wireless Settings screen 
of your 802.11 b/bg/ng wireless access point displays, as shown in 

 below.