Netgear WNDAP350 – ProSAFE Dual Band Wireless-N Access Point User Manual
Advanced Configuration
76
ProSAFE Dual Band Wireless N Access Point WNDAP350
Figure 50. Bridging - Edit WDS Security Profile
Configuring a WNDAP350 as a Point-to-Point Bridge
Figure 51, Wireless point-to-point bridge setup
shows a point-to-point bridge configuration.
Figure 51. Wireless point-to-point bridge setup
To configure a point-to-point bridge
1.
Under the Configuration tab, select Wireless Bridge. Then, select Bridging. The
Bridging screen displays (see
Bridging screen displays (see
Figure 49, Enable Wireless Point-to-Point Bridge
).
2.
Configure the WNDAP350 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.
3.
Configure the WNDAP350 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode.
AP1 must have AP2’s MAC address in its Remote MAC Address field and AP2 must have
AP1’s MAC address in its Remote MAC Address field.
AP1’s MAC address in its Remote MAC Address field.
LAN
Segment 1
Router
AP in
Point-to-Point
Bridge Mode
Point-to-Point
Bridge Mode
AP in
Point-to-Point
Bridge Mode
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
E T H E R N E T
R E S E T
5 - 1 2 V D C
AP2
E T H E R N E T
R E S E T
5 - 1 2 V D C