Netgear FVS318v1 – Prosafe Wireless N VPN Firewall Reference Manual
NETGEAR VPN Configuration FVS318 or FVM318 to Cisco IOS
F-1
M-10146-01
Appendix F
NETGEAR VPN Configuration
FVS318 or FVM318 to Cisco IOS
This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
FVS318 or FVM318 to a Cisco IOS VPN product. This case study follows the VPN Consortium
interoperability profile guidelines (found at
FVS318 or FVM318 to a Cisco IOS VPN product. This case study follows the VPN Consortium
interoperability profile guidelines (found at
http://www.vpnc.org/InteropProfiles/Interop-01.html
).
The configuration screens for the FVS318 and FVM318 are the same.
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table F-1.
Summary
VPN Consortium Scenario:
Scenario 1
Type of VPN
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
Security Scheme:
IKE with Preshared Secret/Key (not Certificate-based)
Date Tested:
April 2003
Model/Firmware Tested:
Gateway A
NETGEAR FVS318 firmware v A1.4 or FVM318 firmware v 1.1
Gateway B
Cisco IOS v 12.2
IP Addressing:
Gateway A
Static IP address
Gateway B
Static IP address