Netgear UTM150 – ProSECURE Unified Threat Management (UTM) Appliance User Manual

Select Local Gateway

Select the WAN1 radio button.

This option is not available for platforms with a single WAN port.

Remote Endpoint

Select the FQDN radio button, and enter srx_client.com in the field to 
the right. 

Enable NetBIOS

Do not enable NetBIOS; leave this check box cleared. (This is the 
default setting.)

Because you are creating a client-to-router configuration, the 

remote IP addresses are likely unknown. 

Enable RollOver

Do not enable rollover; leave this check box cleared. (This is the default 
setting.)

This option is not available for platforms with a single WAN port.

Enable Keepalive

Do not enable keep-alives; select the No radio button. (This is the 
default setting.)

Local IP

Select Subnet.

Start IP Address

Enter 192.168.30.0. 

Subnet Mask

Enter 255.255.255.0. 

Remote IP

Select Any.

If you select Manual Policy from the Policy Type menu (see the General section), the Manual 

Policy Parameters section is enabled onscreen. Because you selected Auto Policy, the Auto Policy 
Parameters section is enabled.

SA Lifetime

Enter 3600 and select Seconds.

Encryption Algorithm

Select 3DES.

Integrity Algorithm

Select SHA-1.

PFS Key Group

Select the PFS Key Group check box, and then select DH Group 2 
(1024 bit).

Select IKE Policy

Select vpn_client. This is the IKE policy that you created in the 
previous section.