Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch Leaflet
Switching Commands
113
ProSafe Managed Switch
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
interface and disables multicast storm recovery.
Format
no storm-control unicast rate
Mode
storm-control flowcontrol
This command enables 802.3x flow control for the switch and only applies to full-duplex
mode ports.
mode ports.
Note:
802.3x flow control works by pausing a port when the port becomes
oversubscribed and dropping all traffic for small bursts of time during
the congestion condition. This can lead to high-priority and/or
network control traffic loss.
the congestion condition. This can lead to high-priority and/or
network control traffic loss.
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note:
This command only applies to full-duplex mode ports.
show storm-control
This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters:
parameters, this command displays global storm control configuration parameters:
•
Broadcast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
•
802.3x Flow Control Mode may be enabled or disabled. The factory default is disabled.
Global Config
Default
disabled
Format
storm-control flowcontrol
Mode
Global Config
Format
no storm-control flowcontrol
Mode
Global Config