Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch Leaflet

This command moves the Primary Management Unit functionality from one switch to another. 
The <fromunit> is the switch identifier on the current Primary Management Unit. The 
<tounit> 

is the switch identifier on the new Primary Management Unit. Upon execution, 

the entire stack (including all interfaces in the stack) is unconfigured and reconfigured with 
the configuration on the new Primary Management Unit. After the reload is complete, all stack 
management capability must be performed on the new Primary Management Unit. To 
preserve the current configuration across a stack move, execute the copy 
system:running-config nvram:startup-config 

(in Privileged EXEC) command 

before performing the stack move. A stack move causes all routes and layer 2 addresses to 
be lost. This command is executed on the Primary Management Unit. The system prompts 
you to confirm the management move.

The movemanagement command does not NSF (non-stop 

forwarding). To move the management unit to the backup unit, use 
initiate failover

Use this command to configure a unit as a Standby Management Unit (STBY).

standby <unit number>

The Standby Management Unit cannot be the current Management 

Unit. The Standby unit should be a management-capable unit.

This command configures a slot in the system. The <unit/slot> is the slot identifier of the 
slot. The <cardindex> is the index into the database of the supported card types, 

switch <oldunit> renumber <newunit>

Global Config

movemanagement <fromunit> <tounit>

Stack Global Config

Stack Global Config