Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch Leaflet

Routing Commands

275

ProSafe Managed Switch

passive-interface default (OSPF)

Use this command to enable global passive mode by default for all interfaces. It overrides
any interface level passive mode. OSPF will not form adjacencies over a passive interface.

Default

Format

passive-interface default

Mode

no passive-interface default

Use this command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to non-passive mode.

Format

no passive-interface default

Mode

passive-interface (OSPF)

Use this command to set the interface or tunnel as passive. It overrides the global passive
mode that is currently effective on the interface or tunnel.

Default

Format

passive-interface {<unit/slot/port>}

Mode

no passive-interface

Use this command to set the interface or tunnel as non-passive. It overrides the global
passive mode that is currently effective on the interface or tunnel.

Format

no passive-interface {<unit/slot/port>}

Mode

timers spf

Use this command to configure the SPF delay time and hold time. The valid range for both
parameters is 0-65535 seconds.

Default

• delay-time—5

• hold-time—10

Format

timers spf <delay-time> <hold-time>

Mode

disabled

Router OSPF Config

disabled

Router OSPF Config