Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch Leaflet
IPv6 Commands
379
ProSafe Managed Switch
maximum-paths (OSPFv3)
This command sets the number of paths that OSPF can report for a given destination where
maxpaths
maxpaths
is platform dependent.
Default
Format
maximum-paths <maxpaths>
Mode
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back
to its default value.
to its default value.
Format
no maximum-paths
Mode
passive-interface default (OSPFv3)
Use this command to enable global passive mode by default for all interfaces. It overrides
any interface level passive mode. OSPF shall not form adjacencies over a passive interface.
any interface level passive mode. OSPF shall not form adjacencies over a passive interface.
Default
Format
passive-interface default
Mode
no passive-interface default(OSPFv3)
Use this command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to non-passive mode.
interface previously configured to be passive reverts to non-passive mode.
Format
no passive-interface default
Mode
passive-interface (OSPFv3)
Use this command to set the interface or tunnel as passive. It overrides the global passive
mode that is currently effective on the interface or tunnel.
mode that is currently effective on the interface or tunnel.
Default
Format
passive-interface {<unit/slot/port> | tunnel <tunnel-id>}
Mode
4
Router OSPFv3 Config
Router OSPFv3 Config
disabled
Router OSPFv3 Config
Router OSPFv3 Config
disabled
Router OSPFv3 Config