Netgear M4100-50-POE (FSM7250Pv1h1) - 48‐port FE + 2 GE Combo L2 Managed PoE Switch Software Guide
Switching Commands
20
M4100 Series ProSAFE
Managed
Switches
no auto-negotiate
This command disables automatic negotiation on a port.
Note:
Automatic sensing is disabled when automatic negotiation is disabled.
auto-negotiate all
This command enables automatic negotiation on all ports.
no auto-negotiate all
This command disables automatic negotiation on all ports.
description
Use this command to create an alpha-numeric description of the port.
mtu
Use the mtu command to set the maximum transmission unit (MTU) size, in bytes, for frames
that ingress or egress the interface. You can use the mtu command to configure jumbo frame
support for physical and port-channel (LAG) interfaces. The MTU size is a valid integer
between 1522–9216 for tagged packets and a valid integer between 1518–9216 for untagged
packets.
that ingress or egress the interface. You can use the mtu command to configure jumbo frame
support for physical and port-channel (LAG) interfaces. The MTU size is a valid integer
between 1522–9216 for tagged packets and a valid integer between 1518–9216 for untagged
packets.
Note:
To receive and process packets, the Ethernet MTU must include any
extra bytes that Layer-2 headers might require. To configure the IP
MTU size, which is the maximum size of the IP packet (IP Header + IP
payload), see
extra bytes that Layer-2 headers might require. To configure the IP
MTU size, which is the maximum size of the IP packet (IP Header + IP
payload), see
Default
enabled
Format
auto-negotiate all
Mode
Global Config
Format
no auto-negotiate all
Mode
Global Config
Format
description <description>
Mode
Interface Config