Netgear M4100-50-POE (FSM7250Pv1h1) - 48‐port FE + 2 GE Combo L2 Managed PoE Switch Software Guide

This command creates an IPv6 access control list (ACL) identified by <name>, consisting of 
classification fields defined for the IP header of an IPv6 frame. The <name> parameter is a 
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 
access list.

If an IPv6 ACL by this name exists, this command enters IPv6-Access-List config mode to 
allow updating the existing IPv6 ACL.

The CLI mode changes to IPv6-Access-List Config mode when you 
successfully execute this command.

This command deletes the IPv6 ACL identified by <name> from the system.

This command changes the name of an IPv6 ACL. The <name> parameter is the name of an 
existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1 
to 31 characters uniquely identifying the IPv6 access list.

This command fails is an IPv6 ACL by the name <newname> already exists.

This command creates a new rule for the current IPv6 access list. Each rule is appended to 
the list of configured rules for the list.

The no form of this command is not supported because the rules 
within an IPv6 ACL cannot be deleted individually. Rather, the entire 
IPv6 ACL must be deleted and respecified.

Format

ipv6 access-list <name>

Mode

Global Config

Format

no ipv6 access-list <name>

Mode

Global Config

Format

ipv6 access-list rename <name> <newname>

Mode

Global Config