Netgear GS724Tv2 – ProSAFE 24-port Gigabit Smart Switch Hardware Manual

@2005 NETGEAR, Inc. NETGEAR, the Netgear logo, Auto Uplink, ProSafe and Everybody’s connecting are trademarks or registered trademarks 
of Netgear, Inc. in the United States and/or other countries. Other brand and product names are trademarks of their respective holders. Information 
is subject to change without notice. All rights reserved.

 

 

 

In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products 
described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or 
circuit layout(s) described herein. 

 

 

It is hereby certified that the NETGEAR GS724T Gigabit Smart Switch has been suppressed in accordance with the conditions set out in the BMPT-
AmtsblVfg 243/1991 and Vfg 46/1992.The operation of some equipment (for example, test transmitters) in accordance with the regulations may, 
however, be subject to certain restrictions. Please refer to the notes in the operating instructions.  

Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right 
to test the series for compliance with the regulations.

 

 

 

This equipment is in the first category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set 
by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines that are aimed at preventing radio 
interference in commercial and/or industrial areas. 

Consequently, when this equipment is used in a residential area or in an adjacent area thereto, radio interference may be caused to equipment 
such as radios and TV receivers.

 

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

 

This device may not cause harmful interference. 

This device must accept any interference received, including interference that may cause undesired operation.

 

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These 
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and 
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:

 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that which the receiver is connected. 

Consult the dealer or an experienced radio/TV technician for help.

 

 

 

This is to certify that the NETGEAR GS724T Gigabit Smart Switch is shielded against the generation of radio interference in accordance with the 
application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55024 Class A (CISPR 22).  

EN 55 022 and EN 55 024 Statements 

This is to certify that the NETGEAR GS724T Gigabit Smart Switch is shielded against the generation of radio interference in accordance with the 
application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class A (CISPR 22) and EN 55 024.

 

 

 

Warning: This is a Class A product. In a domestic environment, this product may cause radio 
interference, in which case the user may be required to take appropriate measures.