Netgear GS752TXS - Stackable Smart Gigabit Ethernet Switch Hardware Manual

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 
environment. This equipment should be installed and operated with minimum distance of 
20 cm between the radiator and your body. 

This transmitter must not be co-located or operating in conjunction with any other antenna or 
transmitter. 

We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole 
responsibility that the GS728TXS/GS752TXS Smart Switch complies with Part 15 of FCC 
Rules. 

Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause 
undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation. This 
equipment uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following methods:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an electrical outlet on a circuit different from that which the 
radio receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Modifications made to the product, unless expressly approved by NETGEAR, Inc., could void 
the user's right to operate the equipment.