Netgear XS728T – ProSAFE® 10 Gigabit Smart Managed Switch Administrator's Guide
Switching
47
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
3.
Click Current members to display the list of ports currently members of that LAG. These
ports are also designated on the display of ports by a check mark.
4.
Click the box, representing each required port to include the port in the LAG.
The following screen shows an example of how to configure LAG1 with ports xg1, xg2,
xg3, xg6 and xg7 as members.
xg3, xg6 and xg7 as members.
5.
Click Apply to send the updated configuration to the switch.
Configuration changes take effect immediately.
LACP Configuration
To configure LACP:
1.
Select Switching
> LAG > Advanced > LACP Configuration.
2.
In the LACP System Priority field, specify the device’s link aggregation priority relative to
the devices at the other ends of the links on which link aggregation is enabled.
A higher value indicates a lower priority. You can change the value of the parameter
globally by specifying a priority from 1 to 65535. The default value is 32768.
3.
Click Apply to send the updated configuration to the switch.
Configuration changes take effect immediately.
LACP Port Configuration
To configure LACP port priority settings:
1.
Select Switching
> LAG > Advanced > LACP Port Configuration.
2.
Select the check box next to the port to configure.
You can select multiple ports to apply the same settings to all selected ports.
3.
Configure the LACP Priority value for the selected port.
The valid range is 0–255. The default value is 128.
4.
Configure the administrative LACP Timeout value.
•
Long. Specifies a long time-out value. This is the default setting.