Netgear GS728TS(B) – ProSAFE 24-Port Gigabit Stackable Smart Switch with 4 SFP uplinks Software Guide

Click Refresh to refresh the page with the most current data from the switch.

ARP Create

Use this page to add a static entry to the ARP table.

To display the page, click Routing 



 ARP, then click the Advanced 



 ARP Create link.

To configure a static ARP entry:

In the IP Address field, enter the IP address that you want to add. It must be the IP 
address of a device on a subnet attached to one of the switch's existing routing 
interfaces.

In the MAC Address field, enter the unicast MAC address of the device. The format is six 
two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.

Click Add to add an ARP Entry.

If you made any changes to existing entries, click Apply to update the settings.

To delete an entry, select the box associated with the entry and click Delete.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 
the latest value of the switch.

Type

The type of the ARP entry. Possible values are:

• Local. An ARP entry associated with one of the switch’s routing 

interface’s MAC addresses.

• Gateway. A dynamic ARP entry whose IP address is that of a router.

• Static. An ARP entry configured by the user.

• Dynamic. An ARP entry which has been learned by the router.

Age

Age since the entry was last refreshed in the ARP Table. The format is 
hh:mm:ss.