Netgear GS728TS(B) – ProSAFE 24-Port Gigabit Stackable Smart Switch with 4 SFP uplinks Software Guide

The Dynamic MAC Address Table shows the MAC addresses and their associated VLANs 
learned on the selected port. Use the Port List menu to select the interface for which you 
want to display data.

VLAN ID

Displays the VLAN ID corresponding to the Last Violation MAC address.

MAC Address

Displays the MAC addresses learned on a specific port.

Click Refresh to refresh the page with the most current data from the switch.

Protected Ports Membership

If a port is configured as protected, it does not forward traffic to any other protected port on 
the switch, but it will forward traffic to unprotected ports. Use the Protected Ports Membership 
page to configure the ports as protected or unprotected.

To display the Protected Ports Membership page, click the Security > Traffic Control > 
Protected Ports link. In the following image, the Unit fields have been expanded to display the 
ports.

To configure protected ports:

Click the orange bar to display the available ports.

Click the box below each port to configure as a protected port. Protected ports are marked 
with an check. No traffic forwarding is possible between two protected ports.

Click Refresh to refresh the page with the most current data from the switch.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 
the latest value of the switch.

If you make changes to the page, click Apply to apply the changes to the system. 
Configuration changes take effect immediately.