Netgear GS728TS(B) – ProSAFE 24-Port Gigabit Stackable Smart Switch with 4 SFP uplinks Software Guide

Precedence fields designating the incoming color value to be used as the conforming 
color. The color of exceeding traffic may be optionally specified as well.

Counting: updating octet and packet statistics to keep track of data handling along traffic 

paths within DiffServ. In this DiffServ feature, counters are not explicitly configured by the 
user, but are designed into the system based on the DiffServ policy being created. See 
the Statistics section of this document for more details.

Assigning QoS Queue: directs traffic stream to the specified QoS queue. This allows a 

traffic classifier to specify which one of the supported hardware queues are used for 
handling packets belonging to the class.

Redirecting: forces classified traffic stream to a specified egress port (physical or LAG). 

This can occur in addition to any marking or policing action. It may also be specified along 
with a QoS queue assignment.

DiffServ Example Configuration

To create a DiffServ Class/Policy and attach it to a switch interface, follow these steps:

From the QoS Class Configuration screen, create a new class with the following 
settings:

Class Name: Class1

Class Type: All

186.

Click the Class1 hyperlink to view the DiffServ Class Configuration screen for this class.

Configure the following settings for Class1:

Protocol Type: UDP

Source IP Address: 192.12.1.0

Source Mask: 255.255.255.0

Source L4 Port: Other, and enter 4567 as the source port value 

Destination IP Address: 192.12.2.0

Destination Mask: 255.255.255.0

Destination L4 Port: Other, and enter 4568 as the destination port value

186.

Click Apply.

From the Policy Configuration screen, create a new policy with the following settings:

Policy Selector: Policy1

Member Class: Class1

191.

Click Add to add the new policy.

Click the Policy1 hyperlink to view the Policy Class Configuration screen for this policy.