Netgear GS752TP - 52PT GE POE SMART SWITCH Administrator's Guide

The following screen displays:

Select the following interface settings for the physical port:

Go To Interface. Enter a port identifier (appears in the Port column) and click the Go 
button.  
The table entry corresponding to the specified port is selected.

Port. Selects the interface for which data is displayed or configured.

Auto Power Down Mode. Determines whether Auto Power Down mode is enabled 

for the port. The factory default is Disable. When the port link is down, the PHY 
automatically goes down for a short period and wakes up to check link pulses. This 
mode allows automatic negotiation and reduces power consumption when no link 
partner is present.

Short Cable Mode. Determines whether Short Cable mode is enabled for the port. 
The factory default is Disable. When the port link up at 1 Gbps, the cable length test is 
performed. If the length of the cable is less than 10 meters, PHYs are put into 
low-power mode so enough power is used to support a short cable. Do not enable 
both EEE and Short Cable modes for a port.

EEE Mode. Determines whether Energy Efficient Ethernet (EEE) mode is enabled for 
the port. Do not enable both EEE and Short Cable modes for a port.

Click APPLY to apply the change to the system. 

Configuration changes take effect immediately.

Use this screen to display or configure Green Ethernet details per interface. 



Select System 







 Green Ethernet Detail.