Netgear RNRX4000 (ReadyNAS 2100) – READYNAS 2100 4TB ADVANCED NETWORK STORAGE - CHASSIS Hardware Manual

Status Information

You can obtain information about the status of your ReadyNAS 1500 or 2100 by reviewing 
the indicators listed in the following table. 

USB status LED

The USB status LED has these states:

On. A USB device is mounted.

Blinking. A USB device is dismounting or a FrontView-scheduled 

backup job is running.

Off. No USB device is mounted.

Disk LEDs (1, 2, 3, 4)

The disk LEDs have these states:

Green. Disk installed

Off. No disk installed.

Blinking: 

- In unison. The Power button was pressed one time; press the 

Power button a second time to initiate a graceful shutdown.

- Slow. Disk synchronization or disk failure.

- Panic. Power button was pressed and held.

- Marching. Volume expansion is in progress.

Disk activity LED

The disk activity LED has these states:

On. A disk is active.

Blinking. A disk is resynchronizing

Off. No disk is active.

Ethernet LEDs (front panel) The Ethernet LEDs have these states:

Green. An Ethernet cable is connected.

Blinking. An Ethernet cable is active.

Off. An Ethernet cable is disconnected.

Ethernet port LEDs (rear 
panel)

Two LED status indicators are built into these ports. The left LED 
indicates port activity. The right LED indicates connection speed as 
follows:

Amber. The port is operating at 1 Gbps.

Green. The port is operating at 100 Mbps.

Off.  The port is operating at 10 Mbps.

Power status LED

The power status LED has these states:

On. The unit is powered on.

Blinking. The unit is powering on or powering off.

Off. Power is not supplied to the unit.