Netgear M4300-52G-PoE+ (GSM4352PA) - 48x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (550W PSU) Software Guide

Use the clear ip ospf stub-router command in Privileged EXEC mode to force OSPF to exit 
stub router mode when it has automatically entered stub router mode because of a resource 
limitation. OSPF only exits stub router mode if it entered stub router mode because of a 
resource limitation or it if is in stub router mode at startup. If OSPF is configured to function 
permanently in stub router mode, the command does not take effect.

This command displays information relevant to the OSPF router. 

Some of the information below displays only if you enable OSPF and 
configure certain features.

Format

clear ip ospf stub-router

Mode

Privileged EXEC

Format

show ip ospf

Mode

Privileged EXEC

Router ID

A 32-bit integer in dotted decimal format identifying the router, about which information is displayed. 

This is a configured value.

OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a 

configured value.

RFC 1583 
Compatibility

Indicates whether 1583 compatibility is enabled or disabled. This is a configured value.

External LSDB 
Limit

The maximum number of nondefault AS-external-LSA (link state advertisement) entries that can be 
stored in the link-state database.

Exit Overflow 
Interval

The number of seconds that, after entering overflow state, a router will attempt to leave overflow 
state.

Spf Delay Time

The number of seconds between two subsequent changes of LSAs, during which time the routing 
table calculation is delayed.

Spf Hold Time

The number of seconds between two consecutive spf calculations.

Flood Pacing 
Interval

The average time, in milliseconds, between LS Update packet transmissions on an interface. This is 
the value configured with the command