Netgear M4300-52G-PoE+ (GSM4352PA) - 48x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (550W PSU) User Manual
Manage Device Security
553
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
6.
Use one of the following methods to select a port:
•
In the Go To Port field, enter the interface in the unit/slot/port format and click on the
Go
Go
button.
•
Next to the Port column, select the check box for the port that you want to configure,
select multiple check boxes to apply the same setting to all selected ports, or select
the check box in the table heading to apply the same settings to all ports.
select multiple check boxes to apply the same setting to all selected ports, or select
the check box in the table heading to apply the same settings to all ports.
7.
Configure broadcast storm control:
•
Recovery Mode
. Enable or disable this option. When you specify Enable and the
broadcast traffic on the specified port exceeds the configured threshold, the switch
blocks (discards) the broadcast traffic. The factory default is Enable.
blocks (discards) the broadcast traffic. The factory default is Enable.
•
Recovery Level Type
. Specify the recovery level as a percentage of link speed or as
packets per second.
•
Recovery Level
. Specify the threshold at which storm control activates. The factory
default is 5 percent of port speed for pps type.
•
Control Action
. Specify the action that occurs when the configured threshold for the
broadcast storm is exceeded. You can select the port to be shut down or traffic on the
port to be rate-limited. The default is RateLimit.
port to be rate-limited. The default is RateLimit.
8.
Configure broadcast storm control:
•
Recovery Mode
. Enable or disable this option. When you specify Enable and the
multicast traffic on the specified port exceeds the configured threshold, the switch
blocks (discards) the multicast traffic. The factory default is Enable.
blocks (discards) the multicast traffic. The factory default is Enable.
•
Recovery Level Type
. Specify the recovery level as a percentage of link speed or as
packets per second.
•
Recovery Level
. Specify the threshold at which storm control activates. The factory
default is 5 percent of port speed for pps type.
9.
Configure broadcast storm control:
•
Recovery Mode
. Enable or disable this option. When you specify Enable and the
unicast traffic on the specified port exceeds the configured threshold, the switch
blocks (discards) the unicast traffic. The factory default is Enable.
blocks (discards) the unicast traffic. The factory default is Enable.
•
Recovery Level Type
. Specify the recovery level as a percentage of link speed or as
packets per second.
•
Recovery Level
. Specify the threshold at which storm control activates. The factory
default is 5 percent of port speed for pps type.
10.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
immediately.