Netgear M4300-52G-PoE+ (GSM4352PA) - 48x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (550W PSU) User Manual

Use one of the following methods to select an interface for the flow poller and sampler:

In the Go To Interface field, enter the interface in the unit/slot/port format and click on 
the Go button.

Next to the Interface column, select the check box for the interface that you want to 
use.

This agent supports physical ports only.

The Poller Receiver Index is the sFlow Receiver associated with this counter poller. 

Use Poller Receiver Index to specify the allowed range for the sFlow receiver. The 
allowed range is 1 to 8. If set to 0, the poller configuration is set to the default and the 
poller is deleted.

Use Poller Interval to specify the maximum number of seconds between successive 

samples of the counters associated with this data source. 

A sampling interval of 0 disables counter sampling. The Allowed range is 0 to 86400 

seconds.

Use Sampler Receiver Index to specify the sFlow receiver for this flow sampler. 

If set to 0, the sampler configuration is set to default and the sampler is deleted. Only 
active receivers can be set. If a receiver expires, then all samplers associated with the 
receiver also expires. The allowed range is 1 to 8.

Use Sampling Rate to specify the statistical sampling rate for packet sampling from this 

source.

A sampling rate of 1 counts all packets. A sampling rate of 0 disables sampling. The 

allowed range is 1024 to 65536.

Use Maximum Header Size to specify the maximum number of bytes to be copied from a 

sampled packet. 

The allowed range is 20 to 256.

Click the Apply button.

The updated configuration is sent to the switch. Configuration changes take effect 
immediately.