Netgear M4300-8X8F (XSM4316S) - Stackable Managed Switch with 16x10G including 8x10GBASE-T and 8xSFP+ Layer 3 Software Guide
Switching Commands
436
M4200 and M4300 Series ProSAFE Managed Switches
GARP Commands
This section describes the commands you use to configure Generic Attribute Registration
Protocol (GARP) and view GARP status. The commands in this section affect both GARP
VLAN Registration Protocol (GVRP) and GARP Multicast Registration Protocol (GMRP).
GARP is a protocol that allows client stations to register with the switch for membership in
VLANS (by using GVMP) or multicast groups (by using GVMP).
Protocol (GARP) and view GARP status. The commands in this section affect both GARP
VLAN Registration Protocol (GVRP) and GARP Multicast Registration Protocol (GMRP).
GARP is a protocol that allows client stations to register with the switch for membership in
VLANS (by using GVMP) or multicast groups (by using GVMP).
set garp timer join
This command sets the GVRP join time per GARP for one interface, a range of interfaces, or
all interfaces. Join time is the interval between the transmission of GARP Protocol Data Units
(PDUs) registering (or reregistering) membership for a VLAN or multicast group. This
command has an effect only when GVRP is enabled. The time is from 10 to 100
centiseconds. The value 20 centiseconds is 0.2 seconds.
all interfaces. Join time is the interval between the transmission of GARP Protocol Data Units
(PDUs) registering (or reregistering) membership for a VLAN or multicast group. This
command has an effect only when GVRP is enabled. The time is from 10 to 100
centiseconds. The value 20 centiseconds is 0.2 seconds.
no set garp timer join
This command sets the GVRP join time to the default and only has an effect when GVRP is
enabled.
enabled.
set garp timer leave
This command sets the GVRP leave time for one interface, a range of interfaces, or all
interfaces or all ports and only has an effect when GVRP is enabled. Leave time is the time to
wait after receiving an unregister request for a VLAN or a multicast group before deleting the
VLAN entry. This can be considered a buffer time for another station to assert registration for
the same attribute in order to maintain uninterrupted service. The leave time is 20 to 600
centiseconds. The value 60 centiseconds is 0.6 seconds. The leave time must be greater
than or equal to three times the join time.
interfaces or all ports and only has an effect when GVRP is enabled. Leave time is the time to
wait after receiving an unregister request for a VLAN or a multicast group before deleting the
VLAN entry. This can be considered a buffer time for another station to assert registration for
the same attribute in order to maintain uninterrupted service. The leave time is 20 to 600
centiseconds. The value 60 centiseconds is 0.6 seconds. The leave time must be greater
than or equal to three times the join time.
Default
20
Format
set garp timer join centiseconds
Mode
Interface Config
Global Config
Format
no set garp timer join
Mode
Interface Config
Global Config
Default
60
Format
set garp timer leave centiseconds
Mode
Interface Config
Global Config