Netgear M4300-8X8F (XSM4316S) - Stackable Managed Switch with 16x10G including 8x10GBASE-T and 8xSFP+ Layer 3 User Manual
Configure System Information
119
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
Possible values are as follows:
•
Routing interface
•
Routing VLAN
•
Routing loopback interface
•
Tunnel interface
•
Service port
VLAN 1 is used as source interface by default.
7.
To add a host that receives SNMP traps, do the following steps:
a. Community Name
. Enter the community string for the SNMP trap packet to be sent to
the trap manager. This name can be up to 16 characters and is case-sensitive.
b. Version
. Select the trap version to be used by the receiver:
•
SNMP V1
. Uses SNMP V1 to send traps to the receiver.
•
SNMP V2
. Uses SNMP V2 to send traps to the receiver.
c. Protocol
. Select the protocol to be used by the receiver. Select IPv4 if the receiver's
address is IPv4 address or IPv6 if the receiver's address is IPv6.
d. Address
. Enter the IPv4 address in x.x.x.x format or the IPv6 address in
xxxx:xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx to receive SNMP traps from this device.
The length of the address cannot exceed 39 characters.
e. Status
. Select the receiver's status:
•
Enable
. Send traps to the receiver
•
Disable
. Do not send traps to the receiver.
f.
Click the Add button.
8.
To make changes, do the following:
•
To modify information about an existing SNMP recipient, select the check box for the
recipient, and change the desired fields.
recipient, and change the desired fields.
•
To delete a recipient, select the check box for the recipient and click the Delete
button.
button.
9.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
immediately.