Netgear M4300-8X8F (XSM4316S) - Stackable Managed Switch with 16x10G including 8x10GBASE-T and 8xSFP+ Layer 3 User Manual

Use one of the following methods to select an interface:

In the Go To Interface field, enter the interface in the unit/slot/port format and click on 
the Go button.

Next to the Interface column, select the check box for the interface that you want to 
configure.

In the Interface Mode field, select the Enable or Disable option to set the administrative 

mode of the selected DVMRP routing interface. 

The default is Disable. 

In the Interface Metric field, enter the DVMRP metric for the selected interface.

This value is sent in DVMRP messages as the cost to reach this network. Valid values 
are 1 to 31. The default value is 1.

Click the Apply button.

The updated configuration is sent to the switch. Configuration changes take effect 
immediately.

The following table describes the nonconfigurable data that is displayed. 

Protocol State

The operational state of the DVMRP protocol on the selected interface, 
either Operational or Non-Operational.

Local Address

The IP address used as a source address in packets sent from the 
selected interface.

Generation ID

The DVMRP generation ID used by the router for the selected 
interface. This value is reset every time an interface is started and is 
placed in prune messages. A change in generation ID informs the 
neighbor routers to discard any previous information about this router.

Received Bad Packets

The number of invalid packets received on the selected interface.

Received Bad Routes

The number of invalid routes received on the selected interface.

Sent Routes

The number of routes sent on the selected interface.