Netgear M4300-8X8F (XSM4316S) - Stackable Managed Switch with 16x10G including 8x10GBASE-T and 8xSFP+ Layer 3 Hardware Manual
Hardware Overview
27
Managed Stackable Switch Series M4300
RJ-45 Ports, Including 1000BASE-T RJ-45 Ports
All copper RJ-45 ports support autosensing. When you insert a cable into an RJ-45 port, the
switch automatically ascertains the maximum speed (10 Mbps, 100 Mbps, 1 Gbps, or
10 Gbps) and duplex mode (half-duplex or full-duplex) of the attached device. All ports
support a Category 5 (Cat 5) unshielded twisted-pair (UTP) cable or higher rated Ethernet
cable terminated with an 8-pin RJ-45 connector.
10 Gbps) and duplex mode (half-duplex or full-duplex) of the attached device. All ports
support a Category 5 (Cat 5) unshielded twisted-pair (UTP) cable or higher rated Ethernet
cable terminated with an 8-pin RJ-45 connector.
To simplify the procedure for attaching devices, all RJ-45 ports support Auto Uplink
technology. This technology allows attaching devices to the RJ-45 ports with either
straight-through or crossover cables.
technology. This technology allows attaching devices to the RJ-45 ports with either
straight-through or crossover cables.
Note:
For 10GBASE-T ports, Ethernet specifications limit a Category 6
(Cat 6) cable length between the switch and the attached device to
328 feet (100 meters).
(Cat 6) cable length between the switch and the attached device to
328 feet (100 meters).
When you insert a cable into the switch’s RJ-45 port, the switch automatically performs the
following actions:
following actions:
•
Senses whether the cable is a straight-through or crossover cable.
•
Determines whether the link to the attached device requires a normal connection (such
as when you are connecting the port to a computer) or an uplink connection (such as
when you are connecting the port to a router, switch, or hub).
as when you are connecting the port to a computer) or an uplink connection (such as
when you are connecting the port to a router, switch, or hub).
•
Automatically configures the RJ-45 port to enable communications with the attached
device. The Auto Uplink technology compensates for setting uplink connections while
eliminating concern about whether to use crossover or straight-through cables when you
attach devices.
eliminating concern about whether to use crossover or straight-through cables when you
attach devices.
USB Port
The switch provides one USB 2.0 port that lets you upgrade firmware from a disk, back up
the configuration to a storage device, and allow for the collection of a memory dump for
debugging purposes.
the configuration to a storage device, and allow for the collection of a memory dump for
debugging purposes.
A device that you attach to the USB port must comply with the following requirements:
•
The USB device must support USB 2.0.
•
The USB device must support the FAT32 or VFAT file type. The NTFS file type is not
supported.
supported.
Because of hardware limitations, the write and read speed to and from a USB device is about
1 Mbps.
1 Mbps.
Note:
In a stack, only the switch that functions as the master can detect and
manage an attached USB device.
manage an attached USB device.