Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch Reference Manual

Basic Virtual Private Networking

4-21

Follow the procedure below to set the LAN IPs on each FVS318v3 to different subnets and 
configure each properly for the Internet. 

The LAN IP address ranges of each VPN endpoint must be different. The connection will fail if 
both are using the NETGEAR default address range of 192.168.0.x. 

In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.

To configure a gateway-to-gateway VPN tunnel using the VPN Wizard: 

1. Log in to the FVS318v3 on LAN A at its default LAN address of 

 with its 

default user name of 

 and password of 

. Click the VPN Wizard link in the 

main menu to display this screen. Click Next to proceed.

Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC 

requirements not covered by these VPNC-recommended parameters, refer to 

     

VPN Tunnel