Netgear FVS318Gv2 – ProSAFE VPN Firewall Series User Manual
Configure a NETGEAR VPN Gateway
127
NETGEAR ProSAFE VPN Client
The following table describes the settings in the IKE Policies page.
Table 13. IKE Policies page settings
Setting
Selection
General
Policy Name
vpn_client.
Direction / Type
Responder (the router responds to the client).
Exchange Mode
Aggressive.
Local
Select Local Gateway
WAN1.
Note:
This option is not available for router with a single WAN port.
Identifier Type
FQDN.
Identifier
srx_router.com.
Remote
Identifier Type
FQDN.
Identifier
srx_client.com.
IKE SA Parameters
Encryption Algorithm
3DES.
Authentication Algorithm
SHA-1.
Authentication Method
Pre-Shared Key.
Pre-shared key
N3tg4ar12.
Note:
This key must be at least 8 characters long. NETGEAR
recommends that you create a key that is not easy to guess.
Diffie-Hellman (DH) Group
Group 2 (1024bit).
SA-Life Time (sec)
28800.
Enable Dead Peer Detection
No. (This is the default setting.)
Extended Authentication
Extended Authentication
No. (This is the default setting.)
Set Up a VPN Policy in the Router
To set up a VPN policy:
1.
Access the router’s web management interface.
For information about how to do this, see the documentation that came with your router.