Netgear FVS318Gv2 – ProSAFE VPN Firewall Series Reference Manual
Default Settings and Technical Specifications
400
NETGEAR ProSAFE VPN Firewall FVS318G v2
Factory Default Settings
You can use the factory default Reset button on the rear panel to reset all settings to their
factory defaults. This is called a hard reset (for more information, see
factory defaults. This is called a hard reset (for more information, see
To perform a hard reset, press and hold the factory default Reset button for approximately
eight seconds (until the Test LED blinks rapidly). The VPN firewall returns to the factory
configuration settings that are shown in the following table.
eight seconds (until the Test LED blinks rapidly). The VPN firewall returns to the factory
configuration settings that are shown in the following table.
Pressing the factory default Reset button for a shorter period causes the VPN firewall to
reboot.
reboot.
The following table shows the default configuration settings for the VPN firewall:
Table 86. VPN firewall factory default configuration settings
Feature
Default Behavior
Login settings
User login URL
https://192.168.1.1
Administrator user name (case-sensitive)
admin
Administrator login password (case-sensitive)
password
Guest user name (case-sensitive)
guest
Guest login password (case-sensitive)
password
WAN settings
WAN IPv4 mode
NAT
WAN IPv6 mode
IPv4 only mode
Stateless IP/ICMP Translation (SIIT)
Disabled
WAN MAC address
Use default MAC address of the VPN
firewall
firewall
WAN MTU size
1500 bytes
1492 bytes for PPPoE connections
1492 bytes for PPPoE connections
Port speed
AutoSense
Dynamic DNS for IPv4
Disabled