Netgear WAG302v1- ProSAFE Dual Band Wireless Access Point Reference Manual
ProSafe Dual Band Wireless Access Point WAG302 Reference Manual (802.11a/g)
2-4
Basic Installation and Configuration
v2.0, May 2006
to communicate with computers on the Ethernet network. In order for this to work correctly, verify
that you have met all of the system requirements, shown on
that you have met all of the system requirements, shown on
.
Setting up the WAG302 Wireless Access Point
To set up the WAG302 Wireless Access Point:
1. Prepare a computer with an Ethernet adapter. If this computer is already part of your network,
record its TCP/IP configuration settings.
2. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 for the
Subnet Mask.
3. Connect an Ethernet cable from the WAG302 to the computer.
4. Turn on your computer, connect the power adapter to the WAG302 and verify the following:
•
The PWR power light goes on.
•
The LAN light of the wireless access point is lit when connected to a powered on
computer.
computer.
•
The WLAN LEDs should be blinking.
Configuring LAN and Wireless Access
To configure the WAG302 Ethernet port for LAN access:
1. Connect to the WAG302 by opening your browser and entering http://192.168.0.230 in the
address field. The WAG302 login screen will appear.
2. Enter admin
for the user name and password for the password, both in lower case letters as
shown in
Tip: Before mounting the WAG302 in a high location, first set up and test the WAG302
to verify wireless network connectivity.