Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch User Manual

VLAN Routing Configuration

Use the VLAN Routing Configuration page to configure VLAN Routing interfaces on the 
system. 

To display the VLAN Routing Configuration page, click Routing







 VLAN Routing.

Use VLAN ID to enter the ID of a VLAN you want to configure for VLAN Routing. The 
field will display the all IDs of the VLAN configured on this switch.

Use IP Address to enter the IP Address to be configured for the VLAN Routing Interface.

Use Subnet Mask to enter the Subnet Mask to be configured for the VLAN Routing 
Interface.

Click ADD to add the VLAN Routing Interface specified in the VLAN ID field to the switch 
configuration.

Click DELETE to remove the VLAN Routing Interface specified in the VLAN ID field from the 
switch configuration.

Port

The interface assigned to the VLAN for routing.

MAC Address

The MAC Address assigned to the VLAN Routing 
Interface

ARP

The ARP protocol associates a layer 2 MAC address with a layer 3 IPv4 address. ProSafe® 
Managed Switches software features both dynamic and manual ARP configuration. With 
manual ARP configuration, you can statically add entries into the ARP table.

ARP is a necessary part of the internet protocol (IP) and is used to translate an IP address to 
a media (MAC) address, defined by a local area network (LAN) such as Ethernet. A station 
needing to send an IP packet must learn the MAC address of the IP destination, or of the next