Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch User Manual
Chapter 6. Managing Device Security
|
469
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
To configure global 802.1X settings:
1.
Select the appropriate radio button in the Port Based Authentication State field to
enable or disable 802.1X administrative mode on the switch.
enable or disable 802.1X administrative mode on the switch.
•
Enable. Port-based authentication is permitted on the switch.
Note:
If 802.1X is enabled, authentication is performed by a RADIUS
server. This means the primary authentication method must be
RADIUS. To set the method, go to Security > Management
Security > Authentication List and select RADIUS as method 1 for
defaultList. For more information, see <pdf>“Authentication List
Configuration” on page
RADIUS. To set the method, go to Security > Management
Security > Authentication List and select RADIUS as method 1 for
defaultList. For more information, see <pdf>“Authentication List
Configuration” on page
•
Disable - The switch does not check for 802.1X authentication before allowing traffic
on any ports, even if the ports are configured to allow only authenticated users.
Default value.
Default value.
2.
Use VLAN Assignment Mode to select one of options for VLAN Assignment mode: enable
and disable. The default value is disable.
and disable. The default value is disable.
3.
Use Users to select the user name that will use the selected login list for 802.1x port
security.
security.
4.
Use Login to select the login to apply to the specified user. All configured logins are
displayed.
displayed.
Table
6-92.
Field
Description
Authentication List
Displays the authentication list which is used by
802.1X.
802.1X.