Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch User Manual
98
|
Chapter 2. Configuring System Information
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
To configure the trap flags:
1.
Use Authentication to enable or disable activation of authentication failure traps by
selecting the corresponding radio button. The factory default is enabled.
selecting the corresponding radio button. The factory default is enabled.
2.
Use Link Up/Down to enable or disable activation of link status traps by selecting the
corresponding radio button. The factory default is enabled.
corresponding radio button. The factory default is enabled.
3.
Use Multiple Users to enable or disable activation of multiple user traps by selecting the
corresponding radio button. The factory default is enabled. This trap is triggered when the
same user ID is logged into the switch more than once at the same time (either via telnet or
the serial port).
corresponding radio button. The factory default is enabled. This trap is triggered when the
same user ID is logged into the switch more than once at the same time (either via telnet or
the serial port).
4.
Use Spanning Tree to enable or disable activation of spanning tree traps by selecting the
corresponding radio button. The factory default is enabled.
corresponding radio button. The factory default is enabled.
5.
Use ACL to enable or disable activation of ACL traps by selecting the corresponding radio
button. The factory default is disabled.
button. The factory default is disabled.
6.
Use DVMRP to enable or disable activation of DVMRP traps by selecting the corresponding
radio button. The factory default is disabled.
radio button. The factory default is disabled.
7.
Use PIM to enable or disable activation of spanning tree traps by selecting the
corresponding radio button. The factory default is disabled.
corresponding radio button. The factory default is disabled.
8.
Use OSPF to enable or disable activation of OSPF traps by selecting the corresponding
radio button. The factory default is enabled. This field can be configured only if the OSPF
admin mode is enabled.
radio button. The factory default is enabled. This field can be configured only if the OSPF
admin mode is enabled.
9.
Click CANCEL to cancel the configuration on the screen. Resets the data on the screen to
the latest value of the switch.
the latest value of the switch.
10.
Click APPLY to send the updated configuration to the switch. Configuration changes take
effect immediately.
effect immediately.