Netgear RD521210 – ReadyDATA 5200 12TB SATA Bundle includes RD5200 with 2 x RD5D6LT01 Disk Packs Software Guide

Configure the settings as explained in the following table:

MTU

Enter the MTU in bytes. The default setting is 1500 bytes.

Speed (Mbps)

Specify the interface speed. Because this setting does not determine the link speed, you 
can specify any setting between 1 Mbps and the maximum speed supported by the 
interface (either 1,000 Mbps or 10,000

 

Mbps).

Duplex

Select the duplex method from the drop-down list:

Auto. The ReadyDATA autosenses the type of duplex connection.

Full. Full duplex, the default setting.

Half. Half duplex.

Click the Apply button. 

By default, each physical Ethernet interface has one virtual NIC (VNIC) that has the following 
configuration:

A name that is based on the number of the associated Ethernet interface. For example, 

vnic0 is associated with eth0.

DHCP-enabled for IPv4

No VLAN membership

The default VNIC has the same numbering as the Ethernet interface that it is associated with 
(eth0 has vnic0; eth1 has vnic1).

You can add multiple VNICs to each single physical Ethernet interface and channel interface.