Netgear AXM764 – ProSAFE 10 Gigabit BASE-LR LITE SFP+ Single Mode Module Installation Guide
Installation
The 10 Gigabit BASE-LR LITE SFP+ module transmits at 10 G bps over
single mode fiber (SMF) for up to 2 Km.
single mode fiber (SMF) for up to 2 Km.
Install the Module
NETGEAR switches automatically detect the AXM764 module. The module
can be inserted or removed while the switch is powered on.
can be inserted or removed while the switch is powered on.
¾
To install a module:
1. Insert the module into one of the available SFP+ module slots, pressing
firmly to seat the module.
2. Make sure that the module latch is in the closed position.
3. Connect a single-mode LC to LC duplex cable to the module.
3. Connect a single-mode LC to LC duplex cable to the module.
Remove the Module
You do not need to power off the switch before removing the module.
¾
To remove a module:
1. Disconnect any cables from the module.
2. Pull down on the module latch.
3. Pull the module out of the module slot.
2. Pull down on the module latch.
3. Pull the module out of the module slot.
Specifications
Specifications
Description
Wavelength
1310nm
Dimensions (H x W x D)
.47 in. x .57 in. x 2.22 in. (11.85 mm x
14.55 mm x 56.50 mm)
14.55 mm x 56.50 mm)
Weight
0.04 lb (20 g)
Operating temperature
23 –158ºF (-5 – 85ºC)
Storage temperature
-40 – 185ºF (-40 –85ºC)
Operative relative humidity
85% at 25ºC
Operating Distance
Up to 2Km on legacy 9/125μm single
mode fiber cables.
mode fiber cables.
Connectors
LC
Max. power consumption
1.1W
MTBF
2310,000 hours (264 years)
Safety Certification
FDA/CDRH, IEC-60825
Compliance
RoHS
ProSAFE 10 Gigabit BASE-LR LITE SFP+
Single Mode Module
AX764