Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 User Manual
Configuration Examples
687
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
Color aware mode takes into consideration the current packet marking when determining
the policing outcome. An auxiliary traffic class is used in conjunction with the policing
definition to specify a value for one of the 802.1p, secondary 802.1p, IP DSCP, or IP
Precedence fields designating the incoming color value to be used as the conforming
color. The color of exceeding traffic can be optionally specified as well.
the policing outcome. An auxiliary traffic class is used in conjunction with the policing
definition to specify a value for one of the 802.1p, secondary 802.1p, IP DSCP, or IP
Precedence fields designating the incoming color value to be used as the conforming
color. The color of exceeding traffic can be optionally specified as well.
•
Counting
. Updating octet and packet statistics to keep track of data handling along traffic
paths within DiffServ. In this DiffServ feature, counters are not explicitly configured by the
user, but are designed into the system based on the DiffServ policy being created. See
the Statistics section of this document for more details.
user, but are designed into the system based on the DiffServ policy being created. See
the Statistics section of this document for more details.
•
Assigning QoS Queue
. Directs traffic stream to the specified QoS queue. This allows a
traffic classifier to specify which one of the supported hardware queues are used for
handling packets belonging to the class.
handling packets belonging to the class.
•
Redirecting
. Forces classified traffic stream to a specified egress port (physical or LAG).
This can occur in addition to any marking or policing action. It can also be specified along
with a QoS queue assignment.
with a QoS queue assignment.
DiffServ Example Configuration
To create a DiffServ Class/Policy and attach it to a switch interface, follow these steps:
1.
From the QoS Class Configuration page, create a new class with the following settings:
•
Class Name: Class1
•
Class Type: All
2.
Click the Class1 hyperlink to view the DiffServ Class Configuration page for this class.
3.
Configure the following settings for Class1:
•
Protocol Type: UDP
•
Source IP Address: 192.12.1.0
•
Source Mask: 255.255.255.0
•
Source L4 Port: Other, and enter 4567 as the source port value
•
Destination IP Address: 192.12.2.0
•
Destination Mask: 255.255.255.0
•
Destination L4 Port: Other, and enter 4568 as the destination port value
4.
Click the Apply button.
5.
From the Policy Configuration page, create a new policy with the following settings:
•
Policy Selector: Policy1
•
Member Class: Class1
6.
Click the Add button.