Netgear M4100-24G-POE+ (GSM7224P) - ProSAFE Gigabit L2+ Managed Switch User Manual

This is the Interval at which EEE LPI data is collected. This is a global setting and is 
applied to all interfaces. The range is 30 to 36000.The default value is 3600. 

In the Max Samples to keep field, enter a value.

This is a global setting and is applied to all interfaces. The range is 1 to 168.The default 
value is 168. 

Click the APPLY button.

The settings are sent to the switch. Configuration changes take effect immediately. These 
changes are not retained across a power cycle unless you save the configuration. See 

405.

Click the REFRESH button to refresh the screen with the most current data from the switch.

The following table describes the Port GreenMode EEE History nonconfigurable fields.

Percentage LPI time per Stack

Time spent in LPI mode per stack since EEE counters were last 
cleared.

Sample No.

Sample Index.

Time Since The Sample Was 
Recorded

Each time the screen is refreshed, this field shows a different time 
because it reflects the difference between the current time and the time 
that the sample was recorded.

Percentage Time spent in LPI 
mode since last sample

Percentage of time spent in LPI mode during the current measurement 
interval. 

Percentage Time spent in LPI 
mode since last reset

Percentage of time spent in LPI mode since EEE LPI statistics were 
reset. 



Prepare your computer with a static IP address in the 169.254.100.0 subnet, for 
example, 169.254.100.201.

Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on 
the switch.

Launch a web browser.

Enter the IP address of the switch in the web browser address field.

The default IP address of the switch is 169.254.100.100. 

The Login screen displays.

Enter the user name and password.