Netgear M4100-24G-POE+ (GSM7224P) - ProSAFE Gigabit L2+ Managed Switch User Manual

Select System > PoE > Basic > PoE Configuration. 

The Unit Selection list displays the current PoE unit. 

To change the PoE unit, select another unit from the menu.

To set the System Usage Threshold, enter a number from 1 to 99. 

This sets the threshold level at which a trap is sent if consumed power is greater than the 
threshold power.

Use Power Management Mode to describe or control the power management algorithm 
used by the PSE to deliver power to the requesting PDs. 

Select Static to indicate that the power allocated for each port depends on the type of 
power threshold configured on the port. Select Dynamic to indicate that the power 
consumption on each port is measured and calculated in real time.

Select the Traps Enable or Disable radio button.

Enable activates the PoE traps. Disable deactivates the PoE traps. The default setting is 
enabled.

Click the APPLY button.

The updated configuration is sent to the switch. Configuration changes take effect 
immediately. 

The following table shows the nonconfigurable fields in the PoE Configuration screen.

Units

Displays the Current PoE Unit. You can change the PoE Unit by 
selecting another unit ID listed here. 

Firmware Version 

Version of the PoE controller's FW image.