Netgear RND2150v1 – READYNAS DUO v1 (500GB: 1 X 500GB) Hardware Manual

Status Information 

You can obtain information about the status of your system by reviewing the indicators listed 
in the following table.

Power button and LED

Press this button to turn on your ReadyNAS system. The LED has these states:

Blinking. Booting or shutting down

On. Powered on

Off. Powered off

Disk LEDs (1, 2, 3, 4)

Each disk bay has an LED associated with it on the front panel of the system. 
The Disk LEDs have these states:

On. Power is on, and the disk is operating normally.

Blinking. The disk was removed, failed, or is resynchronizing. 

Off. The disk bay is empty.

Disk Activity LED

The Disk Activity LED has these states:

Blinking. A disk is active.

Off. No disks are active.

Rear panel Ethernet port 
LEDs

Two LED status indicators are built into this port, one green and one amber. 
They indicate port speed and activity as follows:

Green on, amber off. 1000 Mbps connection speed, no activity

Green blinking, amber off. 1000 Mbps connection speed, activity

Green off, amber on. 10 Mbps or 100 Mbps connection speed, no activity

Green off, amber blinking. 10 Mbps or 100 Mbps connection speed, no 

activity

Green off, amber off. No connection

System Shutdown 

You can shut down your system in one of these ways: 

To shut down the system gracefully, press and hold the Power button until the Power 

button LED flashes and the status display screen displays “Shutting down” (about 5 
seconds). 

To force the system to shut down when it is not responding, unplug it. 

To shut down your system from a computer, use FrontView. For more information, see the 

ReadyNAS RAIDiator 4.1 Software Manual, which is available at 

.