Netgear RD5D (ReadyDATA Disk Packs) – ReadyDATA Disk Packs (SATA/NL-SAS/SAS/SSD) Software Guide
Getting Started
12
ReadyDATA OS 1.4
Note:
If you have difficulty accessing the ReadyDATA Dashboard, or if you
notice unexpected behavior, try using another browser.
notice unexpected behavior, try using another browser.
Install the ReadyDATA in Your Network
Install the ReadyDATA as explained in the installation guide that came with your system. LED
status information and the boot menu are explained in the hardware manual for your system.
status information and the boot menu are explained in the hardware manual for your system.
Connect the ReadyDATA to your network, and make sure that a DHCP server can reach the
ReadyDATA. By default, the ReadyDATA is configured to receive an IPv4 IP address from a
DHCP server.
ReadyDATA. By default, the ReadyDATA is configured to receive an IPv4 IP address from a
DHCP server.
Note:
If the ReadyDATA cannot locate a DHCP server, it is assigned an IP
address through Automatic Private IP Addressing (APIPA). For more
information, see
address through Automatic Private IP Addressing (APIPA). For more
information, see
If you want to use the ReadyDATA with an IPv6 address, first access the ReadyDATA
through the IPv4 address assigned by the DHCP server, and then configure the IPv6 setting
as explained in
through the IPv4 address assigned by the DHCP server, and then configure the IPv6 setting
as explained in
Note:
Note:
If an unexpected condition or failure prevents the ReadyDATA from
booting after you complete an initial set-up procedure, see the LED
status information in the hardware manual for your system.
booting after you complete an initial set-up procedure, see the LED
status information in the hardware manual for your system.