Netgear XAVNB2001 – Powerline AV 200 Wireless-N Extender Kit User Manual

The voltage and current rating of the cable should be greater than the ratings marked on 

the product.

To help prevent electric shock, plug the system and peripheral power cables into properly 

grounded electrical outlets.

Do not use adapter plugs. If you must use an extension cable, use a three-wire cable with 

properly grounded plugs.

Observe extension cable and power strip ratings. Make sure that the total ampere rating 

of all products plugged into the extension cable or power strip does not exceed 80 

percent of the ampere ratings limit for the extension cable or power strip.

To help protect your system from sudden, transient increases and decreases in electrical 

power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).

Position system cables and power cables carefully; route cables so that they cannot be 

stepped on or tripped over. Be sure that nothing rests on any cables.

Do not modify power cables or plugs. 

Always follow your local and national wiring rules.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause undesired operation.

We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole 

responsibility that the Powerline AV 200 Extender (XAVN2001) complies with Part 15 of FCC 

Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause 

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following methods:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.