Netgear EX6130 – WiFi Range Extender Installation Guide

6

To extend the range of your WiFi network, you must connect the extender 
to your existing WiFi network. You can do this in one of two ways:

•  Connect with WPS. For more information, see the following section

.

•  Connect with the NETGEAR installation assistant. For more 

information, see 

Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network without 
typing the network name and password. 

Note: 

WPS does not support WEP network security. If you are using WEP 

security, follow the instructions in 

1.  Press the 

WPS/Mode button on the extender for less than five 

seconds until the WPS/Mode LED blinks.

Note: 

If you press the 

WPS/Mode button for more than five 

seconds, the extender switches to access point mode. When the 
extender switches to access point mode, the WPS/Mode LED and 
Power LED blink and then the WPS/Mode LED turns off and the 
Power LED lights solid green.