KitchenAid 1.4 Cu. Ft. Built-In Trash Compactor with Display, Architect® Series II Use & Care Manual
7
Changing the Custom Panel
Custom Panel with Handle (Model KUCP02IR)
Dimensions
Use these dimensions drawings to create a custom panel for use
without a trim kit. The panel should be
without a trim kit. The panel should be
¹⁄₂" to ⁵⁄₈" (13 mm to
16 mm) thick.
NOTE: A thicker panel may need rounded front corners and a
cutout for access to the handle.
cutout for access to the handle.
Installation
1. Remove the mounting screws attaching the foot pedal to the
compactor. Remove the foot pedal.
2. Remove the mounting screws attaching the toe guard to the
compactor. Remove the toe guard.
3. Remove the mounting screws attaching the decorative panel
to the compactor. Remove the decorative panel and discard
the mounting screws.
the mounting screws.
4. Align the bottom of the custom panel with the bottom of the
drawer front.
5. Secure the panel from the back using four #8 x 1" wood
screws as shown.
6. Reinstall the toe guard using the existing screws and
¹⁄₂"
washer. Then, reinstall the foot pedal.
Custom Panel without Handle (for all C and S models)
Dimensions
Use these dimension drawings to create a custom panel for use
without a trim kit. The panel should be
without a trim kit. The panel should be
¹⁄₂" (13 mm) minimum
thickness.
A. Mounting screws
B. Foot pedal
B. Foot pedal
23
¹³⁄₁₆
"
(60.5 cm)
15"
(38.1 cm)
A
A
B
A. Handle
B. Custom panel
B. Custom panel
C. Panel screw locations
D. Toe guard
D. Toe guard
E. Washer
F. Toe guard screw
F. Toe guard screw
A
B
D
C
E
F
C
15"
(38.1 cm)
25"
(63.5 cm)