KitchenAid 24'' 6-Cycle/5-Option Dishwasher, Architect® Series II Installation Guide
15
NOTE: If the minimum cabinet opening height is less than 34"
(86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher and perforated section
of the insulation blanket to fit into a 33
(86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher and perforated section
of the insulation blanket to fit into a 33
¹⁄₂" (85.1 cm) high cabinet
opening, but the dishwasher will be more difficult to move.
Measurements are approximate. Wheels and legs are preset at
the factory for 34
Measurements are approximate. Wheels and legs are preset at
the factory for 34
¹⁄₂" (87.6 cm).
Cut insulation blanket along perforation for cabinet opening height
of 33½" (85.1 cm). For other cabinet opening heights, do not cut.
of 33½" (85.1 cm). For other cabinet opening heights, do not cut.
Turn both leveler legs to the same height. Put wheels in the
required position determined from “Dishwasher Height
Adjustment Chart.”
required position determined from “Dishwasher Height
Adjustment Chart.”
Built-up floors: If the kitchen floor is higher than the cabinet
opening's floor - for example, the kitchen floor tile does not
extend into the cabinet opening - add shims as needed in the area
shown to bring the dishwasher up to 34" (86.4 cm) below the
countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
opening's floor - for example, the kitchen floor tile does not
extend into the cabinet opening - add shims as needed in the area
shown to bring the dishwasher up to 34" (86.4 cm) below the
countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
Install Door Handle
(on some models)
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing the
setscrews and hex key from the cardboard box. Setscrews are
already installed in the handle. Place handle on mounting studs
with the setscrews facing down. Push the door handle tightly
against the door. Insert the short end of the hex key into the
setscrews. Tighten the setscrews
procedure.
Remove the door handle and hardware bag containing the
setscrews and hex key from the cardboard box. Setscrews are
already installed in the handle. Place handle on mounting studs
with the setscrews facing down. Push the door handle tightly
against the door. Insert the short end of the hex key into the
setscrews. Tighten the setscrews
¹⁄₄ turn past snug.
Retain hex key with Installation Instructions.