KitchenAid 24'' 6-Cycle/6-Option Panel-Ready Dishwasher Installation Instruction
INSTALLATION INSTRUCTIONS
FOR CUSTOM PANEL ATTACHMENT
UNDERCOUNTER DISHWASHER
STAINLESS STEEL TUB
IMPORTANT: Before installing your dishwasher, please use this instruction sheet as a supplement to the installation instructions.
Custom Panel Models Only
Gather these additional tools and parts before starting attachment
of the custom panel. Read and follow the instructions provided in
this Instruction Sheet.
Additional Tools Needed:
³⁄₃₂" Drill bit
Additional Parts Supplied with Custom Panel Models:
of the custom panel. Read and follow the instructions provided in
this Instruction Sheet.
Additional Tools Needed:
³⁄₃₂" Drill bit
Additional Parts Supplied with Custom Panel Models:
Plastic studs (attached to each other by runners) (4)
Short screws (10-16 hex-head screw) (4)
Long screws (8-18 Torx
Short screws (10-16 hex-head screw) (4)
Long screws (8-18 Torx
®†
head screws) (4)
Template (1) (located inside Use and Care Guide bag assembly)
Instruction sheet (1) (located inside Use and Care Guide
bag assembly)
Instruction sheet (1) (located inside Use and Care Guide
bag assembly)
NOTE: The screws supplied are used for only 3¾" (9.5 cm) thick
wooden panel. If the wooden panel is less than 3
wooden panel. If the wooden panel is less than 3
³⁄₈" (8.6 cm) thick,
customer must purchase screws locally.
Make sure all these parts are included in the literature package.
If parts are not included, call 1-800-422-1230. In Canada, call
1-800-807-6777.
Make sure all these parts are included in the literature package.
If parts are not included, call 1-800-422-1230. In Canada, call
1-800-807-6777.
Install Custom Panel
Follow Steps Below:
A customer supplied panel must weigh no more than 16 lbs
(7.3 kg) and must be made to specific dimensions. It is
recommended that a cabinetmaker cut the customer panel
because of the precise dimensions needed.
NOTES:
(7.3 kg) and must be made to specific dimensions. It is
recommended that a cabinetmaker cut the customer panel
because of the precise dimensions needed.
NOTES:
■
The handle for the custom panel is not included.
■
All mounting hardware supplied is for a
³⁄₄" (19.1 mm) thick
wood panel. If a thinner wood panel or materials other than
wood are used, it is the customer’s responsibility to obtain the
proper length screws and adjust the pilot holes accordingly.
wood are used, it is the customer’s responsibility to obtain the
proper length screws and adjust the pilot holes accordingly.
IMPORTANT: Use a moisture-resistant sealer on both sides
and all edges of the panel to avoid damage from moisture.
and all edges of the panel to avoid damage from moisture.
†®TORX, and T15 are registered trademarks of Acument Intellectual Properties, LLC.
W10750117B