KitchenAid 24'' Wine Cellar, Left-Hand Door Swing, Architect® Series II Use & Care Manual

■

Dispose of/recycle all packaging materials.

After you remove all of the packaging materials, clean the inside 
of your wine cellar before using it. See the cleaning instructions in 
“Wine Cellar Care.”

Your wine cellar has four leveling legs. If your wine cellar seems 
unsteady or you want the door to close more easily, adjust the 
wine cellar’s tilt using the instructions below.

1. Plug into a grounded 3 prong outlet. 

2. Move the wine cellar into its final location. 

3. Turn the leveling legs to the right to lower the wine cellar or 

turn the leveling legs to the left to raise it. It may take several 
turns of the leveling legs to adjust the tilt of the wine cellar. 

NOTE: Having someone push against the top of the wine 
cellar takes some weight off the leveling legs. This makes it 
easier to adjust the leveling legs.

4. Open the door and check to make sure that it closes as easily 

as you like. If not, tilt the wine cellar slightly more to the rear 
by turning both front leveling screws to the right. It may take 
several more turns, and you should turn both leveling legs the 
same amount.

1. Open the wine cellar door.

2. Using a Phillips screwdriver, remove the two screws. Push 

both tabs in toward the center to release the base grille from 
the wine cellar.

3. Remove the base grille.

1. Open the wine cellar door.

2. Position the base grille so that both tabs align and the base 

grille snaps into place. Replace the two screws. Tighten the 
screws.

Your wine cellar is heavy. When moving the wine cellar for 
cleaning or service, be sure to protect the floor. Always pull 
the wine cellar straight out when moving it. Do not wiggle 
or “walk” the wine cellar when trying to move it, as floor 
damage could occur.

B

A

A