Xerox Phaser 480 Leaflet
Rear panel switches
Rear panel switches
Switch
Function
Settings
1
Reset/run
Up
: The printer resets and does not accept data while
the switch is in this position.
Down
. The printer runs a self-test, then proceeds to run
normally. Leave the switch
down
for normal operation.
2, 3, and 4
Diagnostics
Up
.
When
only
Switch 4 is moved from
down
to
up
Down
. Normal operation.
5
Start Job
Up
: The Sys/Start job on the hard disk does not run.
Down:
The Sys/Start job runs if the file exists on the disk.
6
Cleaning mode
Up: At power-up, the printer rotates the rollers for a few
seconds, then stops the rotation.
seconds, then stops the rotation.
Down: Normal operation.
7
Baud Rate
Up
: Fixed. Sets the serial communication parameters
to 1200 baud, software flagging, and ignore parity.
Down
: Variable. Lets you change the serial
communication parameters. The factory setting is 9600
baud, software flagging, and ignore parity.
baud, software flagging, and ignore parity.
8 and 9
Color correction