Xerox Paris, a document system Support & Software User Guide
Appendix B: Understanding Serial communications
The Paris Spooler Technical Manual
195
M
O D I F Y I N G T H E C H A R A C T E R S E T
The number of characters within a character selection table is controlled from the
ENGINES.INI file in the PARIS directory (PARIS/ENGINES.INI).
ENGINES.INI file in the PARIS directory (PARIS/ENGINES.INI).
To modify the character set:
1.
Open the ENGINES.INI file. The default settings for the ENGINES.INI file
are as follows:
are as follows:
[XLEng0]
Connect=LOCAL
Spooler=XLSp10
NLink=DLL
CSTLimit=255
Spooler=XLSp10
NLink=DLL
CSTLimit=255
The command line ‘
CSTLimit=XXX
’ describes the current number of
characters in the Character Selection Table (CST). The default setting is 255.
2.
Edit the number of characters required within the range 0 to 255 (for example,
CSTLimit=128
will provide the characters 0 to 127 which correspond to
the letters, numbers and symbols seen on a standard U.S. keyboard).
!
NOTE:
All bitmap fonts that are downloaded are affected.
An example of an edited ENGINES.INI FILE:
[XLEng0]
Connect=LOCAL
Spooler=XLSp10
NLink=DLL
CSTLimit=128
Connect=LOCAL
Spooler=XLSp10
NLink=DLL
CSTLimit=128
#
#
#
#
WARNING!
The syntax rules for editing a file are strict. Command lines are case-sensitive and
must be edited exactly in the format displayed.
must be edited exactly in the format displayed.